Troubleshooting guide

1-44
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring Application Acceleration
Enabling and Disabling the Global Optimization Features
Figure 1-27 SSL Peering Service Window
Step 3
In the SSL Version field, choose the type of SSL protocol to use, or choose Inherited to use the SSL
protocol configured in global SSL settings. Choose SSL3 for the SSL version 3 protocol, choose TLS1
for the Transport Layer Security version 1 protocol, or choose All to use both SSL3 and TLS1 SSL
protocols.
Note For a WAAS Express device, only SSL3 and TLS1 are supported for the SSL Version.
Step 4 To enable verification of peer certificates check Enable Certificate Verification check box. If certificate
verification is enabled, WAAS devices that use self-signed certificates will not be able to establish
peering connections to each other and, thus, not be able to accelerate SSL traffic.
Step 5 Check the Disable revocation check for this service check box to disable OCSP certificate revocation
checking.
Note For a WAAS Express device, this option is not applicable.
Step 6 In the Cipher List pane, choose a list of cipher suites to be used for SSL acceleration between the WAE
device peers, or choose Inherited to use the cipher list configured in SSL global settings.
Note For a WAAS Express device, the list of cipher suites to be used for SSL acceleration is shown
in the Cipher List pane.
See the “Working with Cipher Lists” section on page 1-35 for additional information.
Step 7 Click Submit.