Troubleshooting guide

1-12
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Using the WAE Device Manager GUI
Managing a Cisco WAE
Figure 1-8 Cisco WAE Configuration—Windows Authentication Tab
Step 3 Enter the NetBIOS name.
The NetBIOS name cannot exceed 15 characters nor contain special characters.
Note By default, the NetBIOS name field is automatically populated with the hostname of the file
engine. If this hostname changes, the NetBIOS field is not automatically updated with the new
name.
Step 4 Enter the workgroup or domain name in the short name format, and check the NT Domain check box if
the workgroup/domain is a Windows NT 4 domain.
For example, if your domain name is cisco.com, the short name format is cisco. If your workgroup or
domain is a Windows 2000 or Windows 2003 domain, do not check the NT Domain check box.
If the NT Domain check box is checked, the domain name and short name format can contain a period
(.), but be careful not to enter the fully qualified name for the NT domain.
Step 5 Enter the IP address or hostname for the WINS server that you are using.
Step 6 Check the Use NTLMv2 authentication check box to enable NTLMv2 authentication.
Note Enable NTLMv2 support only if all clients have their security policy set to “Send NTLMv2
responses only/Refuse LM and NTLM.” Using NTLM v2 when the clients do not require it could
cause authentication to fail.