Troubleshooting guide

1-17
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring Traffic Interception
Configuring WCCP on WAEs
Configuring or Viewing the WCCP Settings on WAEs
This section describes how to configure or view WCCP settings on WAEs that are configured as
application accelerators and are not part of an AppNav Cluster (WAEs that are part of an AppNav Cluster
use only the appnav-controller interception method). If you want to configure or view the WCCP settings
on WAEs configured as AppNav Controllers, see “Configuring or Viewing the WCCP Settings on
ANCs” section on page 1-22.
Device group configuration is not possible beginning with WAAS version 5.0. However, you can use the
Copy Settings taskbar icon in the configuration window to copy the settings to other devices in your
network. To ensure consistency, we recommend that you copy the same WCCP settings to all devices in
the same WCCP service farm.
Note Before you do the procedure in this section, you should have already completed a basic WCCP
configuration for your WAAS network that includes the configuration of the TCP promiscuous mode
service as described in the Cisco Wide Area Application Services Quick Configuration Guide.
To modify the WCCP settings for a WAE, follow these steps:
Step 1 From the WAAS Central Manager menu, choose Devices > device-name.
Step 2 Choose Configure > Interception > Interception Configuration. The Interception Configuration
window appears. (See Figure 1-3.)
Note If you are configuring a device using a WAAS version earlier than 5.0, choose Configure >
Interception > WCCP > Settings to configure WCCP settings. The configuration window looks
different but has similar settings.