Troubleshooting guide

1-26
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring AppNav
Configuring an AppNav Cluster
Step 9 Click OK to save the policy and return to the Manage AppNav Policies pane.
Step 10 Click Close to return to the policy configuration window.
Step 11 Add policy rules to the new policy as described in the “Configuring Rules Within an AppNav Policy”
section on page 1-22.
Configuring WAAS Node Optimization Policy
The WAAS node optimization policy controls how traffic that is distributed to the WAAS nodes is
optimized. The optimization policy is configured on the WNs and any ANCs that are also acting as
optimizing nodes.
All WNs in one WNG must have an identical optimization policy configured on them. Otherwise,
optimization of flows is not predictable. The optimization policy can be different for different WNGs.
For information on how to configure the optimization policy, see Chapter 1, “Configuring Application
Acceleration.”
The default optimization policy is listed in Appendix 1, “Predefined Optimization Policy.”
Configuring AppNav Controller ACLs
An AppNav Controller ACL controls what traffic is intercepted by an ANC. You may want to configure
an ANC interception ACL for each ANC in an AppNav Cluster.
For information on how to configure an ANC interception ACL, see the “Configuring Interception
Access Control Lists” section on page 1-28.
Configuring AppNav Cluster Settings
To configure AppNav Cluster settings, follow these steps:
Step 1 From the WAAS Central Manager menu, choose AppNav Clusters > All AppNav Clusters.
The Manage AppNav Clusters window appears, which shows the status of each cluster.
From this window, you can perform the following tasks:
• View an AppNav Cluster topology and edit its settings by clicking on a cluster name.
• Delete an AppNav Cluster by selecting an AppNav Cluster and clicking the Delete icon in the
taskbar of the Manage AppNav Clusters area.
• Create a new AppNav Cluster as described in the steps that follow.
Step 2 Click the name of the cluster whose settings you want to edit.
The cluster topology diagram appears.
Step 3 Choose Configure > AppNav Cluster > AppNav Cluster.
The Cluster Configuration window appears.