Troubleshooting guide

1-18
Cisco Wide Area Application Services Configuration Guide
OL-26579-01
Chapter 1 Configuring AppNav
Configuring an AppNav Cluster
• Create Standby—To create a new standby group with this interface. This choice displays a pane
where you can configure the standby group number, description, IP address, netmask, and shutdown
status.
• To PortChannel n—To add this interface to an existing port channel, where n is the port channel
number.
• To Standby n—To add this interface to an existing standby group, where n is the standby group
number.
• To Bridge n—To add this interface to an existing bridge group, where n is the bridge group number.
• For standby interfaces (right-click within the standby interface group indicator):
– Edit—To edit the standby group settings such as the description, IP address, netmask, primary
interface, and shutdown status.
– Delete Standby n—To delete the standby group.
• For port channel interfaces (right-click within the port channel indicator):
– Edit—To edit the port channel settings such as the port channel number, description, IP address,
netmask, and shutdown status.
– Remove from Standby n—To remove the port channel from standby group n.
– Delete PortChannel n—To delete the port channel.
• For bridge group interfaces (right-click within the bridge group indicator):
– Edit—To edit the bridge group settings such as the bridge group number, description, and link
state propagation status.
– Delete Bridge n—To delete the standby group.
To select an interface:
• Individual interface—Click and selection is indicated by a blue color.
• Standby group—Click on colored or dotted line indicator and selection is indicated by a thick dotted
blue outline around all interfaces in the standby group.
• Port channel or bridge group—Click on colored indicator and selection is indicated by a thick dotted
blue outline around all interfaces in the port channel or bridge group.
You can also perform actions by selecting an interface and clicking the following taskbar icons:
• Add (choices differ depending on the selected entity):
– Create PortChannel—To create a new port channel with this interface.
– Create Bridge—To create a new bridge group with this interface.
– Create Standby—To create a new standby group with this interface.
– To PortChannel n—To add this interface to an existing port channel, where n is the port channel
number.
– To Standby n—To add this interface to an existing port channel, where n is the port channel
number.
• Edit—To edit the selected interface.
• Delete (choices differ depending on the selected entity):
– Remove from Standby n—To remove the port channel from standby group n.
– Delete PortChannel n—To delete the port channel.
– Delete Standby n—To delete the standby group.