User guide

Wireless Ethernet Bridge

• IP Gateway - Sets the IP address of your network’s Gateway.

• Device Name - Sets the Bridge’s name. The default name is Linksys

WET11.

• Allow Firmware Upgrade - When the box is checked, the Bridge accepts

firmware upgrades.

Click the Apply button to save your changes, or click the Cancel button to can-

cel your changes.

Instant Wireless

Series

IP ADDR

The IP Addr screen is used to configure the IP address used by the web and

TFTP servers running on the Bridge. For static mode, the IP address settings

are given on-screen. For DHCP mode, the settings on the IP Addr screen will

be overridden by a DHCP server on your network. Any new settings will not

take effect until the Bridge is rebooted. (To reboot the Bridge, click the Admin

tab, and click the Reboot button.)

• IP Address Mode - Enables you to select the IP address mode: Static or

DHCP (Dynamic Host Configuration Protocol). DHCP mode enables the

DHCP server on your network to override the current IP address settings.

• IP Address - Sets the Bridge’s IP address.

• IP Subnet - Sets the Bridge’s Subnet Mask address.

Note: You may have to refresh this page to see any new settings.

Figure 6-5