Specifications

Configuring the WAP200 Access Point
Configuring Administration Settings
Cisco WAP200 Wireless-G Access Point with Power Over Ethernet and Rangebooster 59
6
Configuring SYSLOG Notification Settings
To configure SYSLOG Notification settings for the access point, follow these steps:
STEP 1 Click Security Monitor > Intrusion Alarm.
STEP 2 Enter the IP address of the system that will store the system log (Logviewer).
STEP 3 Select the e-mail notification alarm type to respond to intrusions. For a list of e-mail
alarm types, see Step 3 on page 58.
STEP 4 In the Security Monitor Server section, enter the IP address for the Security
Monitor Server, a special Syslog server that can record all security monitor events
instead of only selected events.
STEP 5 Click Save.
Configuring Administration Settings
This section describes how to configure the administration settings of the access
point:
• Configuring Management Settings, page 60
• Configuring the Administration Log, page 63
• Restoring Factory Default Settings, page 65
• Upgrading the Firmware, page 66
• Rebooting the Access Point, page 67
• Managing the Access Point’s Configuration, page 68