User guide

ADSL
3425-00669 Rev E 29
WAN Access Options
The WAG310G supports two types of WAN access - ADSL and Ethernet. However,
ADSL WAN access and Ethernet WAN are mutually exclusive. The ADSL WAN is
active by default with one PVC enabled (PVC 0/35).
WAN Connection for PVC
Use this screen to change settings for the selected Wide Area Network (WAN)
connection.
For most WAN connection types, the displayed settings match the settings on the
Setup > ADSL screen; however, additional options appear for IPoE.
Note: PVCs are layer 2 (physical and link), while WAN connections are layer 3,
meaning IP and Point-to-Point (PPP) connections. Each PVC supports multiple
connections. For each PVC, you can configure one IP connection and up to four PPP
over Ethernet (PPPoE) connections. (This type of configuration helps separate out
the different types of traffic.)
Complete the following steps to setup the additional options for a WAN connection
with a connection type of IPoE.
1 Navigate to the ADSL screen.
Path: Setup > ADSL