User guide

Chapter 3 Setup
28 3425-00669 Rev E
5 Click Add Connection at the bottom of the screen (or click Cancel Changes to
cancel your changes). After the connection has been added, the screen refreshes
with the PVC connection selected.
PPPoE (RFC 2364)-New Zealand
Complete the following steps if you are setting up a residential gateway in New
Zealand.
1 Select PPPoE (RFC 2364) from the Connection drop-down menu.
2 For the Virtual Circuit ID, enter 0 for the VPI and 100 for the VCI.
3 Select VCMUX for Multiplexing.
4 Select MultiMode from the DSL Modulation drop-down menu.
5 Obtain the User Name and Password details from your service provider.
6 Click Add Connection at the bottom of the screen (or click Cancel Changes to
cancel your changes). After the connection has been added, the screen refreshes
with the PVC connection selected.
Optional Settings
To configure the Optional Settings, complete the following steps.
1 From the ADSL setup screen, click the Advanced View link. The Optional
Settings fields are located at the bottom of the page.
2 Configure the following fields to setup optional advanced parameters:
 MTU Size—Keep this value in the 1200 to 1500 range. The default MTU is
configured automatically.
 Override MAC Address—Select this option to override the MAC address of
this connection.
 MAC Address—If the Override MAC Address option is enabled, enter the
MAC address you want to use.
3 To add the connection you have configured, click Add Connection, or click
Cancel Changes to cancel your changes. After the connection has been added, a
new screen appears with the PVC connection selected. You can use this screen to
change settings. Refer to the following section WAN Connection for PVC (on
page 29) for details.
4 Click Save Settings.