Specifications

3-709
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
Virtual Blade Configuration Mode Commands
To configure virtual blades on a WAE device, use the virtual-blade global configuration command. To
disable a virtual blade, use the no form of this command.
virtual-blade [virtual-blade-number]
no virtual-blade [virtual-blade-number]
Syntax Description
Defaults No default behavior or values.
Command Modes global configuration
Device Modes application-accelerator
Usage Guidelines Use the virtual-blade command to configure virtual blades on a WAAS device that supports virtual
blades. This command initiates the virtual blade configuration mode as indicated by the (config-vb)
prompt.
Within virtual blade configuration mode, you can use the various commands (device, disk, interface,
and so on) to define the resource parameters for the virtual blade. To return to global configuration mode,
enter the exit command.
Examples The following example shows how to edit virtual blade 2 and put your WAE into virtual blade
configuration mode:
WAE(config)# virtual-blade 2
WAE(config-vb)#
The following example shows that the prompt changes to (config-vb) to indicate virtual blade mode.
WAE(config-vb)# description This-is-my-virtual-blade-description
WAE(config-vb)# exit
WAE(config)#
Related Commands (config-vb) autostart
(config-vb) boot
virtual-blade-number Number of the virtual blade that you want to configure. The range of
valid values depends on the number of virtual blades that your WAE or
WAVE appliance can support.