Specifications

3-594
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
(config) snmp-server trap-source
(config) snmp-server trap-source
To set the source interface from which SNMP traps are sent on a WAAS device, use the snmp-server
trap-source global configuration command. To remove the trap source configuration, use the no form
of this command.
snmp-server trap-source {GigabitEthernet slot/port | PortChannel 1| Standby grpnumber}
no snmp-server trap-source {GigabitEthernet slot/port | PortChannel 1| Standby grpnumber}
Syntax Description
Defaults No system trap source is set.
Command Modes global configuration
Device Modes application-accelerator
central-manager
Examples The following example shows how to configure gigabit Ethernet interface 1/0 as the trap source:
WAE(config)# snmp-server trap-source gigabitethernet 1/0
Related Commands (config) snmp-server community
(config) snmp-server contact
(config) snmp-server enable traps
(config) snmp-server group
(config) snmp-server host
(config) snmp-server mib
(config) snmp-server notify inform
(config) snmp-server user
(config) snmp-server view
snmp trigger
GigabitEthernet
slot/port
Selects a Gigabit Ethernet interface to configure as the trap source. The slot
range is 1–2; the port must be 0. The slot number and port number are
separated with a forward slash character (/).
PortChannel 1 Selects a port channel to configure as the trap source. There is only port
channel 1.
Standby grpnumber Selects a standby group to configure as the trap source. The group number
value is 1.