Specifications

3-527

Cisco Wide Area Application Services Command Reference

OL-21611-01

Chapter 3 CLI Commands

(config) interface standby

To configure a standby interface, use the interface standby global configuration command. To disable

selected options, restore default values, or enable a shutdown interface, use the no form of this

command.

interface Standby 1 {description text | ip address ip_address netmask | shutdown}

no interface Standby 1 {description text | ip address ip_address netmask | shutdown}

Syntax Description

Defaults No default behavior or values.

Command Modes global configuration

Device Modes application-accelerator

central-manager

Usage Guidelines A standby interface cannot be removed if it is configured as the system primary interface.

Note No two interfaces can have IP addresses in the same subnet.

Related Commands show interface

show running-config

show startup-config

Standby 1 Configures a standby interface.

description text Enters a description of the interface.

ip address ip_address

netmask

Specifies the IP address and netmask of the interface.

shutdown Shuts down this interface.