Specifications

3-518
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
(config) interface GigabitEthernet
Defaults The first attached interface in a standby group is defined as the active interface. There are no other
default behaviors or values.
Command Modes global configuration
Device Modes application-accelerator
central-manager
Usage Guidelines Although the CLI contains the no interface option, you cannot apply the no command to an interface.
The software displays the following error message: Removing of physical interface is not permitted.
To configure an interface bandwidth on a WAAS device, use the bandwidth interface configuration
command. The bandwidth is specified in megabits per second (Mbps). Using this option automatically
enables autosense on the interface.
Using the cdp enable command in global configuration mode enables CDP globally on all the interfaces.
If you want to control CDP behavior per interface, use the cdp enable command in interface
configuration mode. The interface level control overrides the global control.
To display the interface identifiers (for example, interface GigabitEthernet 1/0), use the
show running-config or show startup-config commands. The autosense, bandwidth, full-duplex,
half-duplex, ip, and shutdown commands are listed separately in this command reference.
Note When you use the ip address command to change the IP address of an interface that has been shut down,
it automatically brings up that interface by default.
in Applies the specified ACL to inbound packets on the current interface.
out Applies the specified ACL to outbound packets on the current interface.
address ip-address
netmask
Sets the interface IP address and netmask.
secondary (Optional) Specifies that the configured address is a secondary IP address.
If this keyword is omitted, the configured address is the primary IP
address.
dhcp (Optional) Sets the IP address to the address that is negotiated over
Dynamic Host Configuration Protocol (DHCP).
client-id id (Optional) Specifies the client identifier.
hostname name (Optional) Specifies the hostname.
mtu mtusize (Optional) Sets the interface Maximum Transmission Unit (MTU) size in
bytes (88–1500).
shutdown (Optional) Shuts down this interface.
standby 1 (Optional) Sets the standby group number to 1.
primary (Optional) Sets this interface as the active interface in the standby group.