Manualshelf

Specifications

ManualsBrandsCisco ManualsComputer equipmentWAE-7326-K9
551552553554555556557558559560
3-496
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
(config) directed-mode
(config) directed-mode
To configure the mode by which traffic is sent between two WAEs, use the directed-mode global
configuration command. To configure the WAAS device not to use directed mode, use the no form of
this command.
directed-mode enable [port udp-port]
no directed-mode enable [port udp-port]
Syntax Description
Defaults The default communication mode to a peer WAE is transparent mode (not directed mode).
Command Modes global configuration
Device Modes application-accelerator
Examples The following example shows how to configure a WAE for directed mode on the default UDP port of
4050:
WAE(config)# directed-mode enable
Related Commands show statistics auto-discovery
show statistics connection closed
enable Enables directed mode.
port udp-port Sets the UDP port number to use to send traffic between two WAEs.
The default port is 4050.