Specifications

3-441
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
(config) accelerator epm
(config) accelerator epm
To enable the Endpoint Mapper (EPM) application accelerator, use the accelerator epm global
configuration command. To disable the EPM application accelerator, use the no form of this command.
accelerator cifs preposition [remove] directive_id
no accelerator cifs preposition [remove] directive_id
Syntax Description
Defaults The EPM accelerator is enabled by default and will start automatically if the Enterprise license is
installed. The default exception action is coredump.
Command Modes global configuration
Device Modes application-accelerator
Usage Guidelines Use the accelerator epm enable command to enable the acceleration of EPM traffic. The EPM
accelerator must be enabled for the MAPI accelerator to operate.
Examples The following example shows how to enable the EPM application accelerator:
WAE(config)# accelerator epm enable
Related Commands (config) accelerator mapi
show accelerator
show statistics accelerator
enable (Optional) Enables the EPM application accelerator.
exception (Optional) Configures the action to be taken if an exception occurs.
coredump Writes a core file (default).
debug Hangs the system until it is explicitly restarted.
no-coredump Restarts the accelerator and does not write a core file.