Specifications

3-255
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
show startup-config
show startup-config
To display the startup configuration for a WAAS device, use the show startup-config EXEC command.
show startup-config
Syntax Description This command has no arguments or keywords.
Defaults No default behavior or values.
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines Use this EXEC command to display the configuration used during an initial bootup, stored in NVRAM.
Note the difference between the output of this command versus the show running-config command.
Examples The following is sample output from the show startup-config command. It displays the configuration
saved for use on startup of the WAAS device.
WAE# show startup-config
! WAAS version 4.0.0
!
device mode central-manager
!
!
hostname Edge-WAE1
!
!
!
!
!
exec-timeout 60
!
!
primary-interface GigabitEthernet 1/0
!
!
!
interface GigabitEthernet 1/0
ip address 10.10.10.33 255.255.255.0
exit
interface GigabitEthernet 2/0
shutdown
...