Specifications

3-219
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
show ip access-list
show ip access-list
To display the access lists that are defined and applied to specific interfaces or applications on a WAAS
device, use the show ip access-list EXEC command.
show ip access-list [acl-name | acl-num]
Syntax Description
Defaults Displays information about all defined access lists.
Command Modes EXEC
Device Modes application-accelerator
central-manager
Usage Guidelines Use the show ip access-list EXEC command to display the access lists that have been defined on the
WAAS device. Unless you identify a specific access list by name or number, the system displays
information about all the defined access lists, including the following sections:
• Available space for new lists and conditions
• Defined access lists
• References by interface and application
Interception access lists are shown under the Application access list references section.
Examples Table 3-51 describes the fields shown in the show ip access-list command display.
acl-name (Optional) Information for a specific access list, using an alphanumeric
identifier up to 30 characters, beginning with a letter.
acl-num (Optional) Information for a specific access list, using a numeric identifier
(0–99 for standard access lists and100–199 for extended access lists).
Table 3-51 Field Descriptions for the show ip access-list Command
Field Description
Space available:
XX access lists Number of access lists remaining out of 50 maximum lists
allowed.
XXX access list conditions Number of access list conditions remaining out of 500
maximum conditions allowed.
Standard IP access list Name of a configured standard IP access list. Displays a list of
the conditions configured for this list.