Specifications

3-163
Cisco Wide Area Application Services Command Reference
OL-21611-01
Chapter 3 CLI Commands
show accelerator
If you use the show accelerator http command, the output contains an extra section called Accelerator
Config Item, which appears before the Policy Engine Config Item section. In the Accelerator Config
Item section, each item shows the status of an HTTP accelerator configuration item. The Mode column
shows Default if the item is configured with the default setting or User if the item is configured with a
different setting by the user. The Value column shows the current value of the item (Enabled, Disabled,
or an alpha-numeric setting).
Related Commands (config) accelerator cifs
(config) accelerator epm
(config) accelerator http
(config) accelerator mapi
(config) accelerator nfs
(config) accelerator ssl
(config) accelerator video
show statistics accelerator
Policy Engine Config Item: Default
Action
Drop or Use. Specifies the action to be taken if the accelerator
refuses to handle the connection (because of overload or other
reasons). Drop means the connection is dropped, and Use
means the connection uses a reduced set of policy actions (such
as TFO and DRE).
Policy Engine Config Item:
Connection Limit
Connection limit. The limit configured by the accelerator
which states how many connections may be handled before new
connection requests are rejected.
Policy Engine Config Item: Effective
Limit
Effective connection limit. The dynamic limit relating to how
many connections may be handled before new connection
requests are rejected. This limit is affected by resources that
have been reserved, but not yet used.
Policy Engine Config Item:
Keepalive timeout
Connection keepalive timeout in seconds. Keepalive messages
are sent by each accelerator.
Table 3-3 Field Description for the show accelerator Command (continued)
Field Description