Installation guide

9
Release Notes for Cisco Voice Interworking Service Module Release 3.1(1)
OL-3480-01 Rev. C0, January 2003
Installation and Upgrade Procedures
d. put <FW file> POPEYE@SM_1_<slot number of card to upgrade>.FW
quit
Note Do not enter two put commands in the same TFTP session.
Step 3 Proceed to the “Installing VISM Software Updates with PXM1 Cards” section on page 11 to install the
download.
VISM Firmware and Boot Code Download Procedure for PXM1E and PXM45
Step 1 Access the image on the Cisco Web site in order to download the image.
Step 2 Use the ftp node-ip command, where node-ip is the IP address of the node to which you want to
download the image, to download the image.
Step 3 Enter your username and password.
Step 4 Type cd C:FW to access the appropriate directory.
Step 5 Type bin.
Step 6 Use the put image-version, where image-version is the downloaded image from Step 1, to download the
image to your C:FW directory.
Step 7 Type bye to exit the download procedure.
VISM/VISM-PR Firmware Upgrade
Software Release 3.1(1) for VISM/VISM-PR introduces the new VISM-PR card. Complete the
following steps to gracefully upgrade from VISM cards to VISM-PR cards. You must ensure that the
VISM and VISM-PR cards have the minimum boot code version of vism_8t1e1_BT_3.1.00.fw.
The following versions of VISM software Release 3.1(1) are available:
• 300.001.000.000—without CALEA
• 003.051.000.000—with CALEA
Note You do not have to complete these instructions in order to use software Release 3.1(1) for
VISM/VISM-PR; however, see the VISM Features section of the Release Notes for Cisco Voice
Interworking Service Module Release 3.1(0) of features that are not available to you if you do not
perform this upgrade procedure.
VISM cards and VISM-PR cards use the same back cards. There are no new back cards introduced with
this release. In the following procedure:
• Perform the firmware upgrade in the following procedure on the VISM cards; do not remove the
VISM cards and replace them with VISM-PR cards at this time.