Installation guide
Table Of Contents
- Contents
- Features Introduced in Previous Releases of VISM Software
- Elements of Release 3.1(1)
- Installation and Upgrade Procedures
- VISM Firmware and Boot Code Download Procedure for PXM1
- VISM Firmware and Boot Code Download Procedure for PXM1E and PXM45
- VISM/VISM-PR Firmware Upgrade
- VISM to VISM-PR Hardware Upgrade
- Installing VISM Software Updates with PXM1 Cards
- Installing VISM Software Updates with PXM1E or PXM45 Cards
- VISM Boot Code Upgrade Procedure with PXM1 Cards
- VISM Boot Code Upgrade Procedure with PXM1E and PXM45 Cards
- VISM Downgrade Procedure
- Caveats
- Related Documentation
- Obtaining Documentation
- Obtaining Technical Assistance
- Obtaining Additional Publications and Information
15
Release Notes for Cisco Voice Interworking Service Module Release 3.1(1)
OL-3480-01 Rev. C0, January 2003
Caveats
The VISM card will be reset again. When the card comes active, it will have the old-rev firmware running
and will have the old configuration.
Step 5 Reconfigure redundancy group, if required.
Caveats
This section describes resolved and open software caveats for this release of VISM. Caveats describe
unexpected behavior or defects in VISM software.
Resolved Caveats
Table 7 describes the caveats issued against VISM software that have been resolved in software Release
3.1(1) for VISM/VISM-PR.
Table 7 Resolved Caveats for Software Release 3.1(1) for VISM/VISM-PR
DDTS Issue Description
CSCuk38197 VISM replies Line Out Of Service to AUEP after cnflnoos/cnflnis.
CSCdw65362 Announcement file play volume is too high, causes distortion.
CSCdy26382 VISM encapsulates UDPTL for T.38 over RTP
CSCdy36418 CSCdy36418 VISM-PR card must be reset after initial installation into MGX shelf
CSCdy39693 Demotion from GW to Line is not happening
CSCdy46975 vismscalarchange trap not generated with ip address change
CSCdy87408 POS problem, modem calls failing with G729 codec
CSCdy89344 endpts stay active even when gw. is forced oos
CSCdy89423 DLCX always sent to Inactive call agent
CSCdy89462 need a command to display VCCI
CSCdy89474 cnfoamparams / dspoamparams should be accessible in all mode
CSCdy89494 dspmgcgrps and dspdnallips show different status for MGC
CSCdz00374 POS problem, modem calls failing with G729 codec
CSCdz01636 VISM Reboots when Domain Name has a lengthy name
CSCdz06991 E1 CCS NFAS bits not configurable
CSCdz12617 T38 Fax call made on VISM to 5400 causes VISM DSP to crash
CSCdz32964 Dynamic Payload broken due to file merge