Specifications
IP Switching Commands
ip route-cache
ISW-57
Cisco IOS IP Switching Command Reference
May 2008
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.10
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is enabled
IP Flow switching is disabled
IP Distributed switching is disabled
IP Feature Fast switching turbo vector
IP Null turbo vector
IP multicast fast switching is enabled
IP multicast distributed fast switching is disabled
IP route-cache flags are Fast
Router Discovery is disabled
IP output packet accounting is disabled
IP access violation accounting is disabled
TCP/IP header compression is disabled
RTP/IP header compression is disabled
Probe proxy name replies are disabled
Policy routing is disabled
Network address translation is disabled
WCCP Redirect outbound is disabled
WCCP Redirect inbound is disabled
WCCP Redirect exclude is disabled
BGP Policy Mapping is disabled
IP multicast multilayer switching is disabled
The following example shows the configuration information for interface fastethernet 0/0/0:
Router# show running-config
.
.
!
interface FastEthernet0/0/0
ip address 10.1.1.254 255.255.255.0
ip route-cache same-interface
no ip route-cache cef
no ip route-cache distributed
!
Enabling NetFlow Accounting
The following example shows how to enable NetFlow switching:
Router(config)# interface ethernet 0/0/0
Router(config-if)# ip route-cache flow
The following example shows that NetFlow accounting is enabled for interface fastethernet 0/0/0:
Router# show ip interface fastEthernet 0/0/0
FastEthernet0/0/0 is up, line protocol is up
Internet address is 10.1.1.254/24
Broadcast address is 255.255.255.224
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set