Specifications

IP Switching Commands
ip route-cache
ISW-55
Cisco IOS IP Switching Command Reference
May 2008
Examples Configuring Fast Switching and Disabling Cisco Express Forwarding Switching
The following example shows how to enable fast switching and disable Cisco Express Forwarding
switching:
Router(config)# interface ethernet 0/0/0
Router(config-if)# ip route-cache
The following example shows that fast switching is enabled:
Router# show ip interface fastEthernet 0/0/0
FastEthernet0/0/0 is up, line protocol is up
Internet address is 10.1.1.254/24
Broadcast address is 255.255.255.224
Address determined by non-volatile memory
MTU is 1500 bytes
Helper address is not set
Directed broadcast forwarding is disabled
Multicast reserved groups joined: 224.0.0.10
Outgoing access list is not set
Inbound access list is not set
Proxy ARP is enabled
Security level is default
Split horizon is enabled
ICMP redirects are always sent
ICMP unreachables are always sent
ICMP mask replies are never sent
IP fast switching is enabled
IP fast switching on the same interface is disabled
IP Flow switching is disabled
IP Distributed switching is disabled
IP Feature Fast switching turbo vector
IP Null turbo vector
IP multicast fast switching is enabled
The following example shows that Cisco Express Forwarding switching is disabled:
Router# show cef interface fastEthernet 0/0/0
FastEthernet0/0/0 is up (if_number 3)
Corresponding hwidb fast_if_number 3
Corresponding hwidb firstsw->if_number 3
Internet address is 10.1.1.254/24
ICMP redirects are always sent
Per packet load-sharing is disabled
IP unicast RPF check is disabled
Inbound access list is not set
Outbound access list is not set
IP policy routing is disabled
Hardware idb is FastEthernet0/0/0
Fast switching type 1, interface type 18
IP CEF switching disabled
IP Feature Fast switching turbo vector
IP Null turbo vector
Input fast flags 0x0, Output fast flags 0x0
ifindex 1(1)
Slot 0 Slot unit 0 VC -1
Transmit limit accumulator 0x48001A02 (0x48001A02)
IP MTU 1500