Specifications

IP Switching Commands
snmp-server host
ISW-342
Cisco IOS IP Switching Command Reference
May 2008
Command Default This command is disabled by default. A recipient is not specified to receive notifications.
Command Modes Global configuration (config)
• mpls-traffic-eng—Sends MPLS traffic engineering notifications
indicating changes in the status of MPLS traffic engineering tunnels.
• mpls-vpn—Sends MPLS VPN notifications.
• ospf—Sends Open Shortest Path First (OSPF) sham-link notifications.
• pim—Sends Protocol Independent Multicast (PIM) notifications.
• repeater—Sends standard repeater (hub) notifications.
• rsrb—Sends remote source-route bridging (RSRB) notifications.
• rsvp—Sends Resource Reservation Protocol (RSVP) notifications.
• rtr—Sends Response Time Reporter (RTR) notifications.
• sdlc—Sends Synchronous Data Link Control (SDLC) notifications.
• sdllc—Sends SDLC Logical Link Control (SDLLC) notifications.
• snmp—Sends any enabled RFC 1157 SNMP linkUp, linkDown,
authenticationFailure, warmStart, and coldStart notifications.
Note To enable RFC 2233 compliant link up/down notifications, you
should use the snmp server link trap command.
• srp—Sends Spatial Reuse Protocol (SRP) notifications.
• stun—Sends serial tunnel (STUN) notifications.
• syslog—Sends error message notifications (Cisco Syslog MIB). Use the
logging history level command to specify the level of messages to be
sent.
• tty—Sends Cisco enterprise-specific notifications when a TCP
connection closes.
• voice—Sends SNMP poor quality of voice traps, when used with the
snmp enable peer-trap poor qov command.
• vrrp—Sends Virtual Router Redundancy Protocol (VRRP)
notifications.
• vsimaster—Sends Virtual Switch Interface (VSI) Master notifications.
• x25—Sends X.25 event notifications.