Specifications

IP Switching Commands
show route-map ipc
ISW-329
Cisco IOS IP Switching Command Reference
May 2008
The following is sample output of the show route-map ipc command when it is executed on the VIP:
Router# show route-map ipc
Route-map LC IPC Config Updates Received
Name: 4
Match access-list: 2
Match length: 0
Set precedence: 1
Set tos: 0
Set nexthop: 4
Set interface: 0
Set default nexthop: 0
Set default interface: 1
Clean all: 2
Table 56 describes the significant fields shown in the display.
Related Commands
Ta b l e 56 show route-map ipc Field Descriptions
Field Description
Route-map RP IPC Config
Updates Sent
Indicates that IPC messages are being sent from the RP to the VIP.
Name Number of IPC messages sent about the name of the route map.
Match access-list Number of IPC messages sent about the access list.
Match length Number of IPC messages sent about the length to match.
Set precedence Number of IPC messages sent about the precedence.
Set tos Number of IPC messages sent about the type of service (ToS).
Set nexthop Number of IPC messages sent about the next hop.
Set interface Number of IPC messages sent about the interface.
Set default nexthop Number of IPC messages sent about the default next hop.
Set default interface Number of IPC messages sent about the default interface.
Clean all Number of IPC messages sent about clearing the policy routing
configuration from the VIP. When dCEF is disabled and reenabled,
the configuration related to policy routing must be removed
(cleaned) from the VIP before the new information is downloaded
from the RP to the VIP.
Command Description
set ip next-hop verify-availability Configures policy routing to verify if the next hops of a route
map are CDP neighbors before policy routing to that next hop.