Specifications

IP Switching Commands
show route-map ipc
ISW-328
Cisco IOS IP Switching Command Reference
May 2008
show route-map ipc
To display counts of the one-way route map interprocess communication (IPC) messages sent from the
rendezvous point (RP) to the Versatile Interface Processor (VIP) when NetFlow policy routing is
configured, use the show route-map ipc command in user EXEC or privileged EXEC mode.
show route-map ipc
Syntax Description This command has no arguments or keywords.
Command Modes Privileged EXEC
Command History
Usage Guidelines This command displays the counts of one-way route map IPC messages from the RP to the VIP when
NetFlow policy routing is configured. If you execute this command on the RP, the messages are shown
as “Sent.” If you execute this command on the VIP console, the IPC messages are shown as “Received.”
Examples The following is sample output of the show route-map ipc command when it is executed on the RP:
Router# show route-map ipc
Route-map RP IPC Config Updates Sent
Name: 4
Match access-list: 2
Match length: 0
Set precedence: 1
Set tos: 0
Set nexthop: 4
Set interface: 0
Set default nexthop: 0
Set default interface: 1
Clean all: 2
Release Modification
12.0(3)T This command was introduced.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2SX This command is supported in the Cisco IOS Release 12.2SX train. Support
in a specific 12.2SX release of this train depends on your feature set,
platform, and platform hardware.