Specifications

IP Switching Commands
show pxf cpu pbr action
ISW-285
Cisco IOS IP Switching Command Reference
May 2008
show pxf cpu pbr action
To display policy-based routing (PBR) actions configured in the Parallel eXpress Forwarding (PXF), use
the show pxf cpu pbr action command in privileged EXEC mode.
show pxf cpu pbr action map-name
Cisco 10000 Series Router (PRE3)
show pxf cpu pbr [action map-name | tcam map-name | flex-sum]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is useful to determine if an adjacency has been found for a set ip next-hop ip-address
route map configuration command.
action map-name (Optional) Displays PBR action information and redirects the command
output to the route map you specify.
tcam map-name (Optional) Displays VMR (value, plus a mask and result) information stored
in ternary content addressable memory (TCAM) and redirects the command
output to the route map you specify.
Note This option is only available on the PRE3 for the Cisco 10000 series
router.
flex-sum (Optional) Displays summary information describing the amount of memory
allocated in the PXF engine for use by the flexible key construction
microcode. This information is useful for design teams.
Note This option is only available on the PRE3 for the Cisco 10000 series
router.
Release Modification
12.2S This command was introduced.
12.3(7)XI1 This command was introduced on the Cisco 10000 series router for the
PRE2.
12.2(31)SB2 This command was introduced on the Cisco 10000 series router for the
PRE3.