Specifications

IP Switching Commands
show pxf cpu mroute
ISW-283
Cisco IOS IP Switching Command Reference
May 2008
show pxf cpu mroute
To display Parallel eXpress Forwarding (PXF) multicast route (mroute) information, use the show pxf cpu
mroute command in privileged EXEC mode.
show pxf cpu mroute [ipaddress1] [ipaddress2]
Syntax Description
Command Modes Privileged EXEC
Command History
Examples The following example shows PXF mroute information:
Router# show pxf cpu mroute
Shadow G/SG[5624]: s: 0.0.0.0 g: 224.0.1.40 uses: 0 bytes 0 flags: [D ] LNJ
Interface vcci offset rw_index mac_header
In : 0 0x000004
Shadow G/SG[3195]: s: 0.0.0.0 g: 234.5.6.7 uses: 0 bytes 0 flags: [5 ] NJ
Interface vcci offset rw_index mac_header
In : 0 0x000008
Out: Cable5/1/0 5 0x00002C 1B 00000026800001005E05060700010
Out: Cable6/1/1 9 0x000028 1A 00000026800001005E05060700010
Out: Cable6/0/0 6 0x000024 19 00000026800001005E05060700010
Out: Cable5/0/0 3 0x000020 18 00000026800001005E05060700010
Out: Cable7/0/0 A 0x00001C 17 00000026800001005E05060700010
Out: Cable7/1/1 C 0x000018 16 00000026800001005E05060700010
Out: Cable7/1/0 B 0x000014 15 00000026800001005E05060700010
Out: Cable6/1/0 8 0x000010 14 00000026800001005E05060700010
Out: Cable6/0/1 7 0x00000C 13 00000026800001005E05060700010
Out: Cable5/0/1 4 0x000008 12 00000026800001005E05060700010
Table 48 describes the fields shown in the display.
[ipaddress1]
[ipaddress2]
(Optional) Displays PXF mroute information for a particular group or range
of groups.
Release Modification
12.2S This command was introduced.