Specifications

IP Switching Commands
show mls ip static
ISW-250
Cisco IOS IP Switching Command Reference
May 2008
show mls ip static
To display the information for the software-installed static IP entries, use the show mls ip static
command in user EXEC or privileged EXEC mode.
show mls ip static [count [module number] | detail [module number] | module number]
Syntax Description
Command Modes User EXEC
Privileged ECEX
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine
2.
Examples This example shows how to display the software-installed static entries:
Router> show mls ip static
Displaying Netflow entries in Supervisor Earl
DstIP SrcIP Prot:SrcPort:DstPort Src i/f:AdjPtr
--------------------------------------------------------------------
Pkts Bytes Age LastSeen Attributes
---------------------------------------------------
Router>
This example shows how to display detailed information for the software-installed static entries:
Router> show mls ip static detail
Displaying Netflow entries in Supervisor Earl
DstIP SrcIP Prot:SrcPort:DstPort Src i/f:AdjPtr
--------------------------------------------------------------------
Pkts Bytes Age LastSeen Attributes
---------------------------------------------------
QoS Police Count Threshold Leak Drop Bucket Use-Tbl Use-Enable
-----------+------------+---------+-----------+----+-------+-------+----------+
Router>
count (Optional) Displays the total number of static entries.
module number (Optional) Designates the module number.
detail (Optional) Specifies a detailed per-flow output.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17a)SX This command is supported on releases prior to Release 12.2(17a)SX only.
12.2(17b)SXA This command is replaced by the show mls netflow ip sw-installed command.