Specifications

IP Switching Commands
show mls ip routes
ISW-248
Cisco IOS IP Switching Command Reference
May 2008
show mls ip routes
To display the NetFlow routing entries, use the show mls ip routes command in user EXEC or privileged
EXEC mode.
show mls ip routes [non-static | static] [count [module number] | detail [module number] |
module number]
Syntax Description
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine
2.
Examples This example shows how to display the software-installed nonstatic routing entries:
Router> show mls ip routes non-static
Displaying Netflow entries in Supervisor Earl
DstIP SrcIP Prot:SrcPort:DstPort Src i/f:AdjPtr
--------------------------------------------------------------------
Pkts Bytes Age LastSeen Attributes
---------------------------------------------------
Router>
This example shows how to display detailed information for the software-installed nonstatic routing
entries:
Router> show mls ip routes non-static detail
Displaying Netflow entries in Supervisor Earl
DstIP SrcIP Prot:SrcPort:DstPort Src i/f:AdjPtr
--------------------------------------------------------------------
Pkts Bytes Age LastSeen Attributes
---------------------------------------------------
non-static (Optional) Displays the software-installed nonstatic entries.
static (Optional) Displays the software-installed static entries.
count (Optional) Displays the total number of NetFlow routing entries.
module number (Optional) Displays the entries that are downloaded on the specified module; see
the “Usage Guidelines” section for valid values.
detail (Optional) Specifies a detailed per-flow output.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17a)SX This command is supported on releases prior to Release 12.2(17a)SX only.
12.2(17b)SXA This command is replaced by the show mls netflow ip sw-installed command