Specifications

IP Switching Commands
show mls cef maximum-routes
ISW-235
Cisco IOS IP Switching Command Reference
May 2008
show mls cef maximum-routes
To view the current maximum-route system configuration, use the show mls cef maximum-routes
command in user EXEC or privileged EXEC mode.
show mls cef maximum-routes
Syntax Description This command has no arguments or keywords.
Defaults This command has no default settings.
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine
2.
When you enter the mls cef maximum-routes command to change the configuration, the following
additional fields appear in the output of the show mls cef maximum-routes command:
• User configured—Shows configuration changes that you have made.
• Upon reboot—Shows the configuration after a system reboot.
These fields appear if you have not saved the change (using the copy system:running-config nvram:
startup-config command) after entering the mls cef maximum-routes command. See the “Examples”
section for additional information.
Examples This example shows the display after you have entered the mls cef maximum-routes command, saved
the change (copy system:running-config nvram: startup-config command), and rebooted the system:
Router# show mls cef maximum-routes
FIB TCAM maximum routes :
=======================
Current :-
-------
IPv4 - 1k (default)
MPLS - 239k
IPv6 + IP Multicast - 8k (default)
Release Modification
12.2(17b)SXA Support for this command was introduced on the Supervisor
Engine
720.
12.2(33)SRA This command was integrated into Cisco IOS Release
12.2(33)SRA.