Specifications

IP Switching Commands
show mls cef ipv6
ISW-228
Cisco IOS IP Switching Command Reference
May 2008
show mls cef ipv6
To display the hardware IPv6-switching table entries, use the show mls cef ipv6 command in privileged
EXEC mode.
show mls cef ipv6 [vrf vrf-name] [ip-address/mask] [accounting per-prefix] [module number]
show mls cef ipv6 exact-route src-addr [L4-src-port] dst-addr [L4-dst-port]
show mls cef ipv6 multicast tcam [v6mcast-address] [detail] [internal]
Syntax Description
Command Modes Privileged EXEC
Command History
Usage Guidelines This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine
2.
vrf (Optional) IPv6 Virtual Private Network (VPN) routing and forwarding instance
(VRF).
vrf-name (Optional) VRF name.
ip-address/mask (Optional) Entry IPv6 address and prefix mask. Valid values for the mask argument
are from 0 through 128.
accounting
per-prefix
(Optional) Displays per-prefix accounting statistics.
module number (Optional) Displays the entries for a specific module.
exact-route Provides the exact route of IPv6-switching table entries.
src-addr Source IP address.
L4-src-port (Optional) Layer 4-source port number; valid values are from 0 to 65535.
dst-addr Destination IP address.
L4-dst-port (Optional) Layer 4-destination port number; valid values are from 0 to 65535.
multicast tcam Displays IPv6-multicast entries.
v6mcast-address (Optional) IPv6-multicast address.
detail (Optional) Displays detailed hardware information.
internal (Optional) Displays internal hardware information.
Release Modification
12.2(17a)SX This command was introduced on the Supervisor Engine 720.
12.2(17b)SXA The output was changed to display multicast protocol information in the Forwarding
Information Base (FIB) driver.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SRB1 This command was integrated into Cisco IOS Release 12.2(33)SRB1.