Specifications

IP Switching Commands
show mls cef
ISW-201
Cisco IOS IP Switching Command Reference
May 2008
Usage Guidelines The ... indicates that there is additional information.
The following options are for expert users only and are not documented:
• load-info
• detail
• block block-number [entries]
• config-register reg-address}
• diags [detail]
• entry index [detail]
• hardware [module number]
• masks [type]
• used-blocks [type]
• vpn
The MLS-hardware Layer 3 switching applies to IP traffic only.
Use the show mls cef [ip] vrf command to display the VPN routing and forwarding (VRF)
Cisco
Express Forwarding table entries.
You can enter this command on the supervisor engine or switch consoles. Enter the remote login
command to session into the supervisor engine to enter the commands.
The show mls cef command offers three levels of options as follows:
• Protocol-independent options—The following keywords are not protocol specific:
– adjacency
– exact-route
– inconsistency
– module
– rpf
– statistics
– summary
– used-blocks
– vpn
– vrf
• Protocol-dependent keywords—The following keywords specify a protocol:
– eom
– ip
– ipv6
– mpls
• Default keywords—The following keywords display identical output for both the show mls cef and
show mls cef ip commands:
– prefix
– lookup