Specifications

IP Switching Commands
show mls cef
ISW-200
Cisco IOS IP Switching Command Reference
May 2008
Command Default If you do not specify a protocol, the default display is for IP and the global Cisco Express Forwarding
table.
Command Modes User EXEC
Privileged EXEC
Command History
diags (Optional) Displays information about the diagnostic entry. See the “Usage
Guidelines” section for important information.
entry index (Optional) Specifies the specified prefix entry index to display; valid values are
from 0 to 4294967295. See the “Usage Guidelines” section for important
information.
exact-route ... (Optional) Displays information about hardware load sharing; see the show mls cef
exact-route command.
hardware (Optional) Displays a summary of the hardware information. See the “Usage
Guidelines” section for important information.
inconsistency ... (Optional) Displays information about the consistency checker; see the show mls
cef inconsistency command.
masks ... (Optional) Displays information about the mask. See the “Usage Guidelines”
section for important information.
statistics ... (Optional) Displays the number of switched packets and bytes; see the show mls cef
statistics command.
summary ... (Optional) Displays a summary of rates in the hardware for each protocol; see the
show mls cef summary command.
used-blocks (Optional) Displays a list of used blocks; see the “Usage Guidelines” section for
important information.
eom ... Displays information about the EoM protocol; this keyword is not supported.
ip ... Displays information about the IP protocol; see the “Usage Guidelines” section for
additional information.
ipv6 ... Displays information about the IPv6 protocol.
mpls ... Displays information about the Multiprotocol Label Switching (MPLS) protocol;
see the
show mls cef mpls command.
Release Modification
12.2(14)SX Support for this command was introduced on the Supervisor Engine 720.
12.2(17a)SX This command was changed to support the mpls keyword.
12.2(17d)SXB Support for this command on the Supervisor Engine 2 was extended to the 12.2 SX
release. This command was changed to include the load-info keyword on the
Supervisor Engine
720 and the Supervisor Engine 2.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.