Specifications

IP Switching Commands
show ip traffic
ISW-197
Cisco IOS IP Switching Command Reference
May 2008
show ip traffic
To display statistics about IP traffic, use the show ip traffic command in user EXEC or privileged EXEC
mode.
show ip traffic
Syntax Description This command has no arguments or keywords.
Command Modes User EXEC
Privileged EXEC
Command History
Examples The following is sample output from the show ip traffic command:
Router# show ip traffic
IP statistics:
Rcvd: 27 total, 27 local destination
0 format errors, 0 checksum errors, 0 bad hop count
0 unknown protocol, 0 not a gateway
0 security failures, 0 bad options, 0 with options
Opts: 0 end, 0 nop, 0 basic security, 0 loose source route
0 timestamp, 0 extended security, 0 record route
0 stream ID, 0 strict source route, 0 alert, 0 cipso, 0 ump
0 other
Frags: 0 reassembled, 0 timeouts, 0 couldn't reassemble
0 fragmented, 0 couldn't fragment
Bcast: 27 received, 0 sent
Mcast: 0 received, 0 sent
Sent: 0 generated, 0 forwarded
Drop: 0 encapsulation failed, 0 unresolved, 0 no adjacency
0 no route, 0 unicast RPF, 0 forced drop
Drop: 0 packets with source IP address zero
Release Modification
10.0 This command was introduced.
12.2 The output was enhanced to displays the number of keepalive, open, update,
route-refresh request, and notification messages received and sent by a
Border Gateway Protocol (BGP) routing process.
12.2(25)S The command output was modified.
12.2(28)SB This command was integrated into Cisco IOS Release 12.2(28)SB and
implemented on the Cisco 10000 series routers.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.
12.2(33)SXH This command was integrated into Cisco IOS Release 12.2(33)SXH.