Specifications

IP Switching Commands
show cef interface policy-statistics
ISW-132
Cisco IOS IP Switching Command Reference
May 2008
show cef interface policy-statistics
To display Cisco Express Forwarding (CEF) policy statistical information for a specific interface or for
all interfaces, use the show cef interface policy-statistics command in user EXEC or privileged EXEC
mode.
show cef interface [type number] policy-statistics [input | output]
Syntax Description
Command Default By default, this command displays the input statistics only.
Command Modes User EXEC
Privileged EXEC
Command History
Usage Guidelines This command is available on all software switching platforms, such as the Cisco 7200 series router, and
distributed switched platforms, such as the Route Switch Processor (RSP), Gigabit Switch Router
(GSR), and the Catalyst 6000 series router.
This command is not supported on Cisco 7600 series routers that are configured with a Supervisor
Engine
2.
type number (Optional) Interface type and number. A space is not required
between the interface type and number.
input (Optional) Displays Border Gateway Protocol (BGP) policy
accounting statistics for traffic that is traveling through an input
interface.
output (Optional) Displays BGP policy accounting statistics for traffic that
is traveling through an output interface.
Release Modification
12.0(9)S This command was introduced on the Cisco 12000 series Internet routers.
12.0(14)ST This command was integrated into Cisco IOS Release 12.0(14)ST.
12.2(13)T This command was integrated into Cisco IOS Release 12.2(13)T.
12.0(22)S The input and output keywords were added.
The display output was modified to include support for CEF for IPv6
(CEFv6) and distributed (dCEFv6) interface information. Output fields that
support BGP policy accounting were added for the Cisco
7200 series and
Cisco 7500 series platforms.
12.2(14)SX Support for this command was implemented on the Supervisor Engine 720.
12.3(4)T Changes to this command were integrated into Cisco IOS Release 12.3(4)T.
12.2(25)S This command was integrated into Cisco IOS Release 12.2(25)S.
12.2(33)SRA This command was integrated into Cisco IOS Release 12.2(33)SRA.