User guide

DescriptionField
Enter the technology prefix to eliminate the need for entering the IP
address for every Cisco Unified Communications Manager system when
the gw-type-prefix command is configured. For example, you can enter
1#* in this field if you can use the following gw-type-prefix command
on the gatekeeper:
gw-type-prefix 1#* default-technology.
You must enter a value in this field for a gatekeeper-controlled
H.323 client. You can enter only numbers (0-9) and special
characters # and * in this field.
Note
Technology Prefix
On the gatekeeper, enter the specific zone with which Cisco Unified
Communications Manager will register. The zone specifies the total
bandwidth that is available for calls between this zone and another zone.
You must enter a value in this field for a gatekeeper-controlled
phone. You can enter only letters, numbers, spaces, dashes,
dots, and underscores in this field.
Note
Zone
Check this check box to configure the H.323 client gatekeeper as a
controlled gatekeeper.
Gatekeeper Controlled H.323
Client
Do Not Disturb (DND)
Check this check box if you want DND to be enabled.Do Not Disturb
From the drop-down list box, choose a DND option from the following
options:
• None
• Ringer Off
DND Option
From the drop-down list box, choose one of the following options:
• None
• Disable
• Flash Only
• Beep Only
DND Incoming Call Alert
Secure Shell Information
Enter a user ID for the secure shell user. If the phone that you are
configuring does not support secure shell access, this field does not
display. Cisco Technical Assistance Center (TAC) uses secure shell for
troubleshooting. Contact TAC for further assistance.
Secure Shell User
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
OL-28580-01 57
BAT phone templates
REVIEW DRAFT - CISCO CONFIDENTIAL