User guide

CHAPTER 61
Region matrix updates
This chapter provides information to use the Region Matrix menu in BAT to populate or depopulate the
region matrix. The region tables define physical locations, whereas the region matrix tables define available
bandwidth within (intra) and between (inter) regions.
• Populate and depopulate region matrix, page 479
Populate and depopulate region matrix
Use BAT to populate or depopulate the region matrix.
Procedure
Step 1
Choose Bulk Administration > Region Matrix > Populate/Depopulate Region Matrix. The Region Matrix
Configuration window displays.
Step 2
In the Region Matrix Options section, choose Populate Region Matrix or Depopulate Region Matrix based
on what you want to do.
Step 3
In the Job Information section, enter a name for the job. This helps you to identify your job.
Step 4
Select Run now or Run later , depending upon when you want to run the job.
Step 5
Click the Submit button.
Step 6
View the Job Scheduler window to check the status of the job that you submitted.
You can use this window to reschedule the job if required.
Unlike other BAT processes, the progress of a job to populate or depopulate the region matrix cannot
be measured in terms of records passed, failed, or processed. The results can be viewed only after
the entire process is complete.
Note
The number of records criterion is not applicable to this transaction.Note
An administrator can change the region bandwidth defaults, however, this cannot be done through the BAT
menu.
Choose System > Service Parameters in Cisco Unified Communications Manager to access the
region bandwidth defaults. The parameter type specifies Cisco Unified Communications Manager
and the four parameters of interest comprise part of the Clusterwide Parameters (System - Location
and Region) section.
Note
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
OL-28580-01 479