User guide

DescriptionField
PRI Protocol Type Specific Information
For this optional field, check the check box to enable delivery of
the display information element (IE) in SETUP and CONNECT
messages for the calling and called party name delivery service.
By default, the box remains unchecked.
Display IE Delivery
For this optional field, check the check box to include the
Redirecting Number IE in the SETUP message to indicate the first
redirecting number and the redirecting reason of the call when a
call is forwarded. By default, the box remains unchecked.
This setting applies to the SETUP message only on all protocols
for digital access gateways.
Redirecting Number IE
Delivery—Outbound
For this optional field, check the check box to include the
Redirecting Number IE in the SETUP message to indicate the first
redirecting number and the redirecting reason of the call when a
call is forwarded. By default, the box remains unchecked.
This setting applies to the SETUP message only on all protocols
for digital access gateways.
Redirecting Number IE
Delivery—Inbound
Check this check box to include a special leading character byte
(non ASCII, nondisplayable) in the DisplayIE field.
Uncheck this check box to exclude this character byte from the
DisplayIE field.
This check box only applies to the DMS-100 protocol and the
DMS-250 protocol.
Default leaves this setting disabled (unchecked).
Send Extra Leading Character in Display
IE
For this optional field, you may need to specify a value in this field
to force ringback on some PBXs.
The default specifies unchecked. Check this check box only if
users are not receiving ringback tones on outbound calls.
When this setting is enabled, Cisco Unified Communications
Manager sends Q.931 setup messages out digital (that is,
non-H.323) gateways with the Progress Indicator field set to
non-ISDN.
This message notifies the destination device that the Cisco Unified
Communications Manager gateway is non-ISDN and that the
destination device should play inband ringback.
This problem usually associates with Cisco Unified
Communications Managers that connect to PBXs through digital
gateways.
Setup of Non-ISDN Progress Indicator
IE Enable
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
392 OL-28580-01
Gateway configuration settings
REVIEW DRAFT - CISCO CONFIDENTIAL