User guide

DescriptionField
Choose one of the following values to specify whether channel
selection is presented as a channel map or a slot map:
• Number—B-channel usage always presents a channel map
format.
• Slotmap—B-channel usage always presents a slotmap format.
• Use Number When 1B—Channel usage presents a channel
map for one B-channel but presents a slotmap if more than
one B-channel exists. This represents the default value.
Channel IE Type
Specify the digital encoding format. Choose one of the following
formats:
• a-law: Use for Europe and the rest of the world.
• mu-law: Use for North America, Hong Kong, Taiwan, and
Japan.
PUnified CMType
For this optional field, enter the rate, in 1/8-second increments, at
which the spans are brought in service. The delay occurs when
many PRI spans are enabled on a system and the Inhibit Restarts
at PRI Initialization check box is unchecked. The default value
specifies 32.
For example, set the first five cards to 0 and set the next five cards
to 16. (Wait 2 seconds before bringing them in service.)
Delay for First Restart
Enter the time, in 1/8-second increments, between restarts. The
delay occurs when a PRI RESTART is sent if the Inhibit Restarts
check box is unchecked. The default value specifies 4.
Delay Between Restarts
A restart message confirms the status of the ports on a PRI span.
If RESTARTS are not sent, Cisco Unified Communications
Manager assumes that the ports are in service. By default, the box
gets checked.
When the D-channel successfully connects with another PRI trunk
D-channel, it sends restarts when this box is unchecked.
Inhibit Restarts at PRI Initialization
Check the check box to enable the Cisco Unified Communications
Manager advanced service parameter, Change B-Channel
Maintenance Status. This service parameter allows you to take
individual B-channels out of service while the B-channels are
active.
Uncheck this check box to disable the service parameter Change
B-Channel Maintenance Status.
Default leaves this field unchecked.
Enable Status Poll
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
386 OL-28580-01
Gateway configuration settings
REVIEW DRAFT - CISCO CONFIDENTIAL