User guide

DescriptionField
Choose the automated alternate routing (AAR) group for this
device. The AAR group provides the prefix digits that are used to
route calls that are otherwise blocked due to insufficient bandwidth.
An AAR group setting of None specifies that no rerouting of
blocked calls will be attempted.
AAR Group
Enter the appropriate load information for the custom software for
gateway. The values that you enter here override the default values
for this gateway.
To use the default load, leave this field blank.
Load Information
This device uses the user locale setting of the device's device pool
to determine whether to send Unicode and whether to translate
received Unicode information.
For the sending device, if you check this check box and the user
locale setting in the device's device pool matches the terminating
phone's user locale, the device sends Unicode. If the user locale
settings do not match, the device sends ASCII.
The receiving device translates incoming Unicode characters based
on the user locale setting of the sending device's device pool. If
the user locale setting matches the terminating phone's user locale,
the phone displays the characters.
The phone may display junk characters if the two ends of the trunk
configure user locales that do not belong to the same language
group.
Transmit UTF-8 for Calling Party Name
Multilevel Precedence and Preemption (MLPP) Information
Enter a hexadecimal value for the MLPP domain that is associated
with this device. Ensure that the value is blank or a value between
0 and FFFFFF.
MLPP Domain (e.g., “0000FF”)
Interface Information
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
384 OL-28580-01
Gateway configuration settings
REVIEW DRAFT - CISCO CONFIDENTIAL