User guide

DescriptionField
Choose the automated alternate routing (AAR) group for this device.
The AAR group provides the prefix digits that are used to route calls
that are otherwise blocked due to insufficient bandwidth. An AAR group
setting of None specifies that no rerouting of blocked calls will be
attempted.
AAR Group
From the drop-down list box, choose an MLPP domain to associate with
this device. If you leave the value <None>, this device inherits its MLPP
domain from the value that was set for the device's device pool. If the
device pool does not have an MLPP Domain setting, this device inherits
its MLPP Domain from the value that was set for the MLPP Domain
Identifier enterprise parameter.
MLPP Domain
Check this box to enable this gateway to interpret special DTMF signals
as MLPP precedence levels.
Handle DTMF Precedence Signals
Enter the appropriate firmware load information for the gateway.
The values that you enter here override the default values for this
gateway.
Load Information
Choose the order in which channels or ports are allocated for outbound
calls from first (lowest number port) to last (highest number port) or
from last to first.
Valid entries include TOP_DOWN (first to last) or BOTTOM_UP (last
to first). If you are not sure which port order to use, choose TOP_DOWN.
Port Selection Order
Choose one of the following digit sending types for out-dialing:
• DTMF—Dual-tone multifrequency. Normal touchtone dialing
• MF—Multifrequency
• PULSE—Pulse (rotary) dialing
Digit Sending
From the drop-down list box, choose the locale that is associated with
the gateway. The network locale identifies a set of detailed information
to support the hardware in a specific location. The network locale
contains a definition of the tones and cadences that the device uses in a
specific geographic area.
Choose only a network locale that is already installed and
supported by the associated devices. The list contains all
available network locales for this setting, but not all are
necessarily installed. If the device is associated with a network
locale that it does not support in the firmware, the device will
fail to come up.
Note
Network Locale
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
OL-28580-01 381
Gateway configuration settings
REVIEW DRAFT - CISCO CONFIDENTIAL