User guide

DescriptionField
From the drop-down list box, enable or disable whether Cisco Unified
Communications Manager inserts a trusted relay point (TRP) device
with this media endpoint. Choose one of the following values:
• Default—If you choose this value, the device uses the Use
Trusted Relay Point setting from the common device
configuration with which this device associates.
• Off—Choose this value to disable the use of a TRP with this
device. This setting overrides the Use Trusted Relay Point setting
in the common device configuration with which this device
associates.
• On—Choose this value to enable the use of a TRP with this
device. This setting overrides the Use Trusted Relay Point setting
in the common device configuration with which this device
associates.
A Trusted Relay Point (TRP) device designates an MTP or transcoder
device that is labeled as Trusted Relay Point.
Cisco Unified Communications Manager places the TRP closest to
the associated endpoint device if more than one resource is needed
for the endpoint (for example, a transcoder or RSVP Agent).
If both TRP and MTP are required for the endpoint, TRP gets used
as the required MTP.
See TRP Insertion Requirements in the Cisco Unified Communications
Manager System Guide for details of call behavior.
Use Trusted Relay Point
Choose the order in which ports are chosen. If you are not sure which
port order to use, choose TOP_DOWN:
• TOP_DOWN—Selects ports in descending order, from port 1
to port 8.
• BOTTOM_UP—Selects ports in ascending order, from port 8
to port 1.
Port Selection Order
Enter the appropriate firmware load information for the gateway.
The values that you enter here override the default values for this
gateway.
Load Information
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
370 OL-28580-01
Gateway configuration settings
REVIEW DRAFT - CISCO CONFIDENTIAL