User guide

• T1 Primary Rate Interface (PRI) trunks for ISDN services in North America—Currently available only
for Cisco VG200 gateways
• E1 Primary Rate Interface (PRI) trunks for ISDN services in Europe—Currently available only for
Cisco VG200 gateways.
• Digital Access T1 protocol trunks
Before You Begin
Before adding the VG200 gateways to the Cisco Unified Communications Manager database, you must first
configure the gateway by using the Cisco IOS software command line interface (CLI). For gateway
configuration procedures and commands, refer to the configuration documentation that is supplied with the
gateway.
Procedure
Step 1
Create a Cisco VG200 gateway template to define common values for a set of gateways and ports. See the
Create Cisco VG200 gateway template, on page 356.
Step 2
Create a CSV data file to define individual values for each gateway and port that you want to add. See the
CSV data file creation for Cisco VG200 gateways, on page 405.
Step 3
Insert gateways and ports in the Cisco Unified Communications Manager database. See the Insert gateways
and ports to Cisco Unified Communications Manager, on page 412.
Related Topics
Topics related to gateway configuration settings, on page 398
Add Cisco Catalyst 6000 (FXS) gateways and ports using BAT
You can use BAT to add Cisco Catalyst 6000 (FXS) gateways to the Cisco Unified Communications Manager
database. You can also add FXS ports on the Cisco Catalyst 6000 (FXS) analog interface modules for analog
devices. You must configure a Gateway Directory Number template to associate with these FXS ports and a
Catalyst 6000 (FXS) ports template before adding these ports to the Cisco Unified Communications Manager
database.
Before You Begin
Before using BAT to add the FXS ports for the analog interface modules, you must install the Cisco Catalyst
6000 gateway by performing these tasks:
1
Configure the gateway by using Cisco IOS software command line interface. See the documentation that
was supplied with your gateway for configuration instructions.
2
Use Cisco Unified Communications Manager Administration to add the Cisco Catalyst 6000 gateway in
the Cisco Unified Communications Manager database. In Cisco Unified Communications Manager
Administration, choose Device > Gateway and click Add New. Choose the Cisco Catalyst 6000 24 Port
FXS Gateway and device protocol and then click Next. For more information, refer to the Cisco Unified
Communications Manager Administration Guide.
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
352 OL-28580-01
Cisco gateway additions
REVIEW DRAFT - CISCO CONFIDENTIAL