User guide

DescriptionField
Enter the number of seconds (between 4 and 30) after which an MLPP
precedence call will be directed to the alternate party for this directory
number if this directory number and its call forwarding destination have not
answered the precedence call.
Leave this setting blank to use the value that is set in the Cisco Unified
Communications Manager enterprise parameter, Precedence Alternate Party
Timeout.
MLPP No Answer Ring
Duration
Enter the phone number (or mask) that is sent for Caller ID information
when a call is placed from this line.
You can enter a maximum of 30 numbers and “X” characters. The Xs
represent the directory number and must appear at the end of the pattern.
For example, if you specify a mask of 972813XXXX, an external call from
extension 1234 displays a caller ID number of 9728131234.
External Phone Number Mask
You can configure up to 184 calls for a line on a device in a cluster, with
the limiting factor being the device. As you configure the number of calls
for one line, the calls available for another line decrease.
The default specifies 4. If the phone does not allow multiple calls for each
line, the default specifies 2.
For CTI route points, you can configure up to 10,000 calls for each port.
The default specifies 5000 calls.
Use this field in conjunction with the Busy Trigger field.
Maximum Number of Calls
This setting, which works in conjunction with Maximum Number of Calls
and Call Forward Busy, determines the maximum number of calls to be
presented at the line. If maximum number of calls is set for 50 and the busy
trigger is set to 40, incoming call 41 gets rejected with a busy cause (and
will get forwarded if Call Forward Busy is set). If this line is shared, incoming
calls do not get rejected unless all the lines are busy.
Use this field in conjunction with Maximum Number of Calls for CTI route
points. The default specifies 4500 calls.
Busy Trigger
Add phone lines to existing phones and UDPs
You can add lines to exiting phones and UDP templates.
Before You Begin
• You must have a BAT template for this transaction.
• You must have a CSV data file for this transaction.
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
OL-28580-01 157
Add phone lines to existing phones and UDPs
REVIEW DRAFT - CISCO CONFIDENTIAL