User guide

DescriptionField
Choose one of the following options from the drop-down list box:
• Default—Use the value that you configured in the Party
Entrance Tone service parameter.
• On—A tone plays on the phone when a basic call changes to
a multi party call; that is, a barge call, cBarge call, ad hoc
conference, meet-me conference, or a joined call. In addition,
a different tone plays when a party leaves the multi party call.
If the controlling device, that is, the originator of the multi
party call has a built-in bridge, the tone gets played to all
parties if you choose On for the controlling device. When the
controlling device, for example, the conference controller, no
longer remains present on the call or if the controlling device
cannot play the tone, Cisco Unified Communications Manager
does not play the tone even if you choose On.
• Off—A tone does not play on the phone when a basic call
changes to a multi party call.
Party Entrance Tone
Multiple Call/Call Waiting Settings
You can configure up to 184 calls for a line on a device in a cluster,
with the limiting factor being the device. As you configure the
number of calls for one line, the calls that are available for another
line decrease.
The default specifies 4. If the phone does not allow multiple calls
for each line, the default specifies 2.
For CTI route points, you can configure up to 10,000 calls for each
port. The default specifies 5000 calls.
Use this field in conjunction with the Busy Trigger field.
Maximum Number of Calls
This setting, which works in conjunction with Maximum Number
of Calls and Call Forward Busy, determines the maximum number
of calls to be presented at the line. If maximum number of calls is
set for 50 and the busy trigger is set to 40, incoming call 41 gets
rejected with a busy cause (and will get forwarded if Call Forward
Busy is set). If this line is shared, be aware that all the lines must
be busy before incoming calls get rejected.
Use this field in conjunction with Maximum Number of Calls for
CTI route points. The default specifies 4500 calls.
Busy Trigger
Forwarded Call Information Display for This Device
Check this check box to include the caller name in the display when
a forwarded call is received. Default leaves this check box checked.
Caller Name
Cisco Unified Communications Manager Bulk Administration Guide, Release 9.1(1)
74 OL-28580-01
BAT phone templates
REVIEW DRAFT - CISCO CONFIDENTIAL