User guide

Chapter 2
Configuration
2
Gigabit USB Adapter
Chapter 2:
Configuration
This chapter will take you through all the steps necessary
to set up, configure, and install the Gigabit USB Adapter.
The steps are also available to use the Utility to uninstall
the driver from the Adapter, if you should ever need to do
so. After you set up the Adapter with the Setup Utility, you
will install the Adapter into your Notebook PC.
IMPORTANT: Make sure that you don’t connect
the Adapter until instructed to do so or the
setup won’t work
Setup Utility
Insert the Setup Utility CD into your PC’s CD-ROM 1.
drive.
The Setup Utility’s Welcome screen should appear 2.
on your monitor. If it does not, this means the Setup
Utility is not automatically running as it should. Start
the Setup Utility manually by clicking the Start button,
selecting Run, and typing d:\setup.exe (where “D” is
your PC’s CD-ROM drive).
Driver Installation
Click the Install button to continue this Setup Utility
and install the driver. Click the Uninstall tab and
button to uninstall the driver. Clicking the User Guide
button opened this User Guide. To contact Linksys,
click the Contact Us tab and button. To exit this Setup
Utility, click the Exit tab and button.
Setup and Driver Installation
If you haven’t already done so, click the 1. Install button.
The Welcome screen will appear. Click Next to continue
the installation.
Welcome Screen
The Choose Destination Location folder will appear 2.
next. To install the driver in the default folder location,
click Next.
File Location