Installation guide

97
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Example
The following example configures a timeline specification. The collection process starts as soon as the
command succeeds. The inr parameter will be monitored. A total of 640 values will be collected.
Of the N tones in a burst, the average value of all the tones (for the burst) is retrieved as one data sample.
Each data sample will be right shifted by 2 bits. Twenty successive (right-shifted) data samples will be
added together and reported as one value (of the 640 values in total).
When the threshold inr lowThreshold 2 is reached, the collection will stop and the results will be
printed.
UBR04# radio timeline inr 640 dec 20 pre 2 tone average trigger inr
lowThreshold 2
show interfaces radio (tlspec)
Use this command in privileged EXEC mode to display the details of the currently configured timeline
specifications. If none of the optional parameters are specified then all the timeline specifications on the
modem card are displayed. If the statParam antenna_num combination only is specified, then the
configuration setup on the default will be displayed. if the [dsp dspId] parameter is specified, then the
configurations on that DSP will be displayed.
show interfaces radio slot/port tlspec [statParam antenna_num [dsp dspId]]
Syntax Description
Refer to radio timeline for syntax descriptions.
Example
The following example displays the inr timeline specification configured for the modem card in port 3,
slot 0 of the Cisco uBR7200 series router:
UBR04# show interfaces radio 3/0 tlspec inr
Classinr
Resource Id1
Buffer size50
Number of buffers20
Collection method30
Tone Selectionaverage
Stop threshold attributein
Stop threshold typedownChange
Stop antenna number1
Print optionsoff
Dsp Number3
Default T1false
negCrossing The limit that applies only when the threshParam is decreasing in value.
postTrigBufMgt Specifies the position of the trigger in the data collected. If it is 1, then most of
the data collected prior to the trigger is returned. If it is 2, most of the data
returned is captured after the occurrence of the trigger.