Installation guide

Table Of Contents

Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration

78-6030-03

Command Reference

presummationShift If decimationFactor is specified, then successive data samples get added. This

can potentially cause an overflow. The presummationShift value specifies the

number of bits by which the data sample should be right-shifted before being

added. Specifying a presummationShift value will result in less precise

individual data samples but provides a mechanism to analyze the behavior over

longer duration of time.

pss (0 . . 32)

print {on | off} Specifies whether or not the collected values should be printed out

when the collection completes. The default is on.

tone {circular | average | number tone-number} Every burst of signal data contains

samples from N frequency tones. This parameter identifies which of those

frequency tones should be used.

circular Implies successive data samples should use successive frequency tones.

average Implies successive data samples should average the burst data over all the N

frequencies and then use that value.

number Specifies that data from a particular frequency in the burst should be reported.

tone-number for in and inr

{ {0 . . 27} for 12 MHz high, 6 MHz high }

{ {0 . . 33 } otherwise }

for constVariance

{ {0 . . 216} for 12 MHz high }

{ {0 . . 198} for 12 MHz med, low }

{ {0 . . 108 } for 6 MHz high }

{ {0 . . 99 } for 6 MHz med, low }

trigger Specifies when the collection has to be stopped. The threshParam threshType

antenna_num parameters uniquely identify a threshold specification. When this

threshold is reached, the timeline will be stopped and the data collected.

threshParam {in | inr | constVariance | timingOffset | freqOffset | syncStatus |

receivedPower | gainSettingsIF | gainSettingsRF}

threshType {highThreshold | lowThreshold | upChange | downChange | posCrossing |

negCrossing}

highThreshold An upper limit for the threshParam being monitored.

lowThreshold A lower limit for the threshParam being monitored.

upChange The positive change limit allowed for the threshParam being monitored.

downChange The negative change limit allowed for the threshParam being monitored.

posCrossing The limit that applies only when the threshParam is increasing in value.