Installation guide

93
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Syntax Description
Example
The following command sends an output of type rx-timedomainchannel-ant2-h2n to the serial port:
UBR04# radio scope-output dsprx1a RxTimeDomainChannelAnt2H2n
radio timeline
A timeline is a sequence of data values collected for a specified attribute. The amount of data collected
is controlled by the tlSize parameter. The maximum size is determined by the hardware memory size.
Use this command in privileged EXEC mode to configure a timeline collection specification with the
software. The collection starts as soon as the command succeeds, and continues until the trigger occurs
or the timelineStop command is executed.
For every timeline defined, antenna_num and tone are conditional. The antenna_num is required for the
attributes in, receivedPower, GainSettingsIF, gainSettingsRF, and totalGain. The tone may be
optionally specified for the attributes in, inr, and constVariance.
Use the no version of this command to delete a timeline specification.
Use the timelineStop form of the command to stop a currently executing timeline specification.
Use the timelineStart form of the command to start a stopped timeline specification.
Unless an error occurs, no notifications are displayed on the console.
radio timeline statParam antenna_num [dsp dspId] tlSize [decimationFactor df][presummationShift
pss] [print {on | off}] [tone {circular | average | number tone-number] [trigger threshParams
threshType (antenna_num) postTrigBufMgt]
no radio timeline statParam antenna_num [dsp dspnum]
radio interface radio slot/port timelineStart statParam (antenna_num)[dsp dspnum]
radio interface radio slot/port timelineStop statParam (antenna_num)[dsp dspnum]
dspId {dsprx1a (Receive DSP 1a) | dsprx1b (Receive DSP 1b) | dsprx2a (Receive DSP 2a) |
dsprx2b (Receive DSP 2b) | dsprx3a (Receive DSP 3a) | dsprx3b (Receive DSP 3b) |
dsptx1 (Transmit DSP 1) | dsptx2 (Transmit DSP 2)}
outputType {rx-rawburst-ant1-y1n | rx-rawburst-ant1-y2n | rx-spectrum-ant1-y1k |
rx-spectrum-ant1-y2k | rx-timedomainchannel-ant1-h1n |
rx-timedomainchannel-ant2-h2n | rx-freqdomainchannel-ant1-h1k |
rx-freqdomainchannel-ant2-h2k | rx-constellation-zhatk | tx-codec-input |
tx-ifft-input | tx-round-output | sync-burst-timecost-func | sync-freq-offset-costfunc
| sync-fll-freq-correlation | sync-fll-train-tone-correlation | sync-fll-fft-spectrum}
slot Positive integer representing the Cisco uBR7200 series slot number.
port Positive integer representing the port number on that slot.