Installation guide

90
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Note The Tx and Rx types cannot be mixed. Rx and Sync types can be mixed. When a radio snapshot
command is issued, up to four signal attributes may be requested at once, one from each set.
radio snapshot dspId snapshotType
no radio snapshot dspId snapshotType
show interfaces radio slot/port {snapshot | snapdata} dspId
radio interface radio slot/port snapcapture dspId
radio interface radio slot/port snapclear dspId
Syntax Description
Type Set1 Set2 Set3 Set4
Rx y1n(x1) y2n(x2) y2k(x8) y1k(x4)
h2k(x80) h1k(x40) h1n(x10) h2n(x20)
– – zhat(x100) –
Sync – FreqCorr(x8000) FreqOffCF(x2000)
(*)
BrstTimeCF(x1000)
(**)
– FLL_FFT_Sp(x20000
)
– TT_FCorr(x10000)
Tx CodecIn(x200) IFFTIn(x400) – RoundOut(x800)
* FreqOffCF cannot be mixed with Set1.
** BrstTimeCF cannot be mixed with Set2.
dspId {dsprx1a (Receive DSP 1a) | dsprx1b (Receive DSP 1b)
| dsprx2a (Receive DSP 2a) | dsprx2b (Receive DSP 2b)
| dsprx3a (Receive DSP 3a) | dsprx3b (Receive DSP 3b) |
dsptx1 (Transmit DSP 1) | dsptx2 (Transmit DSP 2)}
snapshotType Unsigned number. Up to four different snapshot types may
be requested at once. When more than one snapshot is
requested in a command, all snapshots will be captured
from the same DSP. See snapshot type definitions below.
rx-rawburst-ant1-y1n (0x01) Represents a snapshot of the received signal for RF
resource 1. For every sample, the real and imaginary
components are captured.
Units: (I, q)
Value: 32-bit quantities
rx-rawburst-ant2-y2n (0x02) Represents a snapshot of the received signal for RF
resource 2. For every sample, the real and imaginary
components are captured.
Units: (I, q)
Value: 32-bit quantities